Cost by state

Heat pump running cost in Alabama

In Alabama, a heat pump and a 95% AFUE gas furnace cost about the same to run. Against propane, heating oil and electric baseboard the answer is different, and all four are below.

This is a data page. The figures here are computed from EIA prices for Alabama rather than written. The reasoning behind them is in the gas furnace comparison and the methodology, and how the data is collected is on the how this site is made page.

Alabama energy prices, 2025-12, 2026-01, 2026-02

The December 2025 to February 2026 EIA heating season mean, pulled . Every figure on this page is in the CSV and JSON download, published under CC BY 4.0.

FigureValueSource
Residential electricity$0.161/kWhEIA, by state
Residential natural gas$1.59/thermEIA, by state
Propane$2.90/galEIA, PADD 3, Gulf Coast
Heating oil$3.82/galEIA, United States average
Electricity to gas price ratio2.96 to 1derived
Breakeven ratio for this equipment2.78 to 1derived
Annual heating degree days3,118EIA, ESC division

Alabama ranks 12 of 45 states by electricity to gas price ratio, where 1 is most favourable to a heat pump.

Cost to deliver one kWh of heat in Alabama

Current systemFuel price$ per kWh heatHeat pump verdictDifference
Natural gas furnace $1.59/therm 0.0571 Too close to call tie
Propane furnace $2.90/gallon 0.1139 Cheaper to run 46%
Heating oil furnace or boiler $3.82/gallon 0.1134 Cheaper to run 46%
Electric resistance (baseboard or furnace) $0.161/kWh 0.1608 Cheaper to run 62%
Heat pump, COP 2.64$0.161/kWh0.0610

Assumes a cold climate heat pump at HSPF2 11.0 with 10% of heat from electric resistance backup. Propane and heating oil are published by EIA regionally rather than by state, so those are the nearest regional figures. Change any of it on the calculator.

Rough monthly cost in Alabama

SystemWinter monthPer year
Gas furnace, 95% AFUE$120$751
Heat pump, effective COP 2.64$128$802

An 1,800 sq ft home of typical construction, at 3,118 annual heating degree days for the ESC census division. The square foot coefficient behind this is a rule of thumb rather than a measurement and can be wrong by half in either direction. How this is worked out, and a better method if you have a year of bills.

What this page does not tell you

Running cost only, at state average prices. It excludes equipment and installation cost, rebates, and the fact that a heat pump also replaces an air conditioner. State averages hide large differences between utilities inside Alabama, and this page cannot know your balance point or how much backup heat your system would actually use, which is the input that moves the answer most.

No household data for Alabama yet

Nobody in this dataset has reported from Alabama, or from anywhere else in the East South Central census division. That is a real gap rather than an oversight: almost every household report this site has collected comes from cold climate discussion, and the warmer divisions are barely represented anywhere in public.

It also matters more here than it would in New England. A heat pump in Alabama rarely reaches the temperatures where backup heat takes over, which is the single thing that ruins the arithmetic further north, so the figures on this page are more likely to hold and there is nothing on record to confirm that.

If you run a heat pump in Alabama, a winter month's kWh, your floor area and the month it covers is enough to add a row, and it can be sent here. In the meantime, the dataset as it stands shows what the spread looks like elsewhere, and the winter bill guide covers how to work out whether your own bill is reasonable without a local comparison.

Where to go from here

Because the two are within a few percent in Alabama, the answer will be decided by your own rate and your own house rather than by the state average, and a dual fuel system sidesteps the choice entirely.

If you already have a heat pump and the bill is higher than you expected, start with the four things that make a winter bill run high and how to tell which one is yours. If somebody has told you your usage is insane, the questions people actually ask when the bill arrives covers what that comparison is usually missing.

If you are still choosing, the comparison depends on what you are replacing: a gas furnace, propane, heating oil, or electric baseboards, where the heat pump wins by a wide margin in every state including this one.

And if you want to check the arithmetic rather than take it, every constant and limitation is listed, the data is rebuilt from EIA on a documented schedule, and the things this site has got wrong are published rather than quietly edited.

The reasoning behind these numbers

The verdict at the top of this page turns on one threshold, and that threshold is set by your equipment rather than by your climate, which is the single most misunderstood thing about heat pump running cost. The price it is compared against comes from EIA, averaged across December to February, and using any other window inflates the gas price enough to flip the verdict in fifteen states. This site published that mistake before catching it.

Use your own rates

State averages are a starting point, not your bill.

Open the calculator